china samsung flace file needed?


bakup flace file name MT6572__samsung__SM-G900__klte__4.4.2__ALPS.JB3.MP.V1.45 this file needed

phone is stuck on logo i formet it with cm tool but not repair
i read file i have bakup also any way to repair my file then flace it again to recover my phone

phone info

Operation : Check / Read Info [ v1.38 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone…
Phone found! [ 8 ]
Sync…
Inital regs read done
Boot Info :
BB_CPU_ID : 6572
BB_CPU_HW : CA01
BB_CPU_SW : 8A00
BB_CPU_SB : 0000
BB_CPU_NM : [MediaTek] MT6572_S00
Processing BROM stage
BLVersion : 0x01
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending
DA Ver : MTK_AllInOne_DA_v7.1533.03
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 90014A4834473164040502A1D66E71DF
DA Stat : v4.2 on BBID : 0x88
DA Sent. Configure setting now …
DA started successuflly
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0090 , OEM : 014A
[eMMC] : FLASH_INF : [HYNIX] , d1G4
[eMMC] : FLASH_CID : 90014A4834473164040502A1D66E71DF
[eMMC] : FLASH_EXT : 0x00400000 , 0x00400000 , 0x00400000
[eMMC] : FLASH_LEN : 0x00000000E9000000
[eMMC] : FLASH_UCP : 3728 MiB
INT RAM : 0x00020000
EXT RAM : 0x20000000
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

[AP] : Initial info read Ok!

Brand : samsung
ProdName : k3gduosctc
ProdModel : SM-G900
Device : klte
AndroidVer: 4.4.2
MTKxCPU : MT6572
MTKxPRJ : ALPS.JB3.MP.V1.45

Done!
Elapsed: 00:00:13
Reconnect Power/Cable!