2. Connect the Soldered TP Connections to ATF Box
3. Disconnect the USB Cable and Wait until the
the ATF Software will tell you to Connect the USB.
ERROR: EMMC WAS NOT Detected! (CMD1)
Check your Test Point Soldering!
CMD1 Reply: 0x00000000
1. Already revised again the pinout.
2. i am using adapter 5 in 1 modified
3. already connected with only RJ45
4. have you another solution please?
note: How do i know if the resistor value is coorect? (where go conneted
THANKS IN ADVANCE.