HUAWEI Ascending y220 MODEL Y220-U10 NAND NOT SUPPORTED


HUAWEI Y220 MODEL Y220-U10 NAND NOT SUPPORTED?

http:// free image uploader

LOGS

Card found : S/N : B5873186 , v0129
Chinese Miracle II [MTK module] v 1.40

Operation : Check / Read Info [ v1.40 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone…
Device boot not done
Check Drivers
Try again

Boot Error!

Operation Failed
Elapsed: 00:00:27
Reconnect Power/Cable!

Operation : Check / Read Info [ v1.40 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone…
Phone found! [ 20 ]
Sync…
Inital regs read done
Boot Info :
BB_CPU_ID : 6572
BB_CPU_HW : CA01
BB_CPU_SW : 8A00
BB_CPU_SB : 0000
BB_CPU_NM : [MediaTek] MT6572_S00
Processing BROM stage
BLVersion : 0x01
SecCfgVal : 0x00000000
BromVersion : 0xFF
BLVersion : 0x01
Preloader Status : Alive
Processing DA stage
DA Select done , sending
DA Ver : MTK_AllInOne_DA_v7.1533.03
NAND_ID : 009800BC009000660076001500010000
eMMC_ID : 00000000000000000000000000000000
DA Stat : v4.2 on BBID : 0x88
DA Sent. Configure setting now …
DA started successuflly
NAND FlashIC initialized
[NAND] : FLASH_VEN : 0x008D , [TOSHIBA] TYBC0A111557KC
[NAND] : FLASH_DIE : 0098 00BC 0090 0066 0076 0015 0001
[NAND] : FLASH_LEN : 0x20000000
[NAND] : FLASH_EXT : 1000/0040/00/NIM_Px-1
INT RAM : 0x00020000
EXT RAM : 0x10000000
BOOT TYPE : NAND_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

Info read not done 🙁 Erased phone or unsupported FlashIc?
You can change settings : Settings -> Other -> NAND init Mode

Done!
Elapsed: 00:00:08
Reconnect Power/Cable!

BR
BARUGATEC