I9100 32GB dead boot problem


Hello everyone i got problem by jtag I9100 32G

Help me to solve this problem.
Here is my log

Code:

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung I9100 V1.0.4850.415]

Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.81V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (VZL00M, 0x000774000000 Bytes = 29.81 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (VZL00M, 0x000000080000 Bytes = 0.50 MB)

No Resurrection Data is available for the eMMC Chip with Capacity = 29.81GB
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 14.68GB

Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000004000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000008000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x00000000C000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000010000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000014000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000018000 is handled as Cut Excess.