Lenovo A7000 Plus(A7000-a) IMEI DONE – Android 6.0

CPU MTK 6752

Code:

Start  at : [26-09-2016 / 13:36:35]
Operation : Repair Security [ v1.56 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 4 ]
Sync...
Inital Boot Ok!
BB_CPU_PID : 6752
BB_CPU_NME : [MediaTek] MT6732|MT6752_S00
BB_CPU_EXT : 0xCA01 , 0x8A00 , 0x0000
Processing BROM stage
Settings for BROM configured!
SecCfgVal : 0x00000000
BromVer  : 0x00FF
BLVersion : 0x0001
PreLoader : Active [ Boot with PL ]
BootLdrSS : NORMAL with PRELOADER
Processing DA stage
DA Select done, will use MTK_AllInOne_DA_v5.1624.16.07
Sending and initialize DA ...
Running DA ver.4.2 on BBID : 0x8F
NAND Flash : NOT INSTALLED
eMMC Flash : 150100513832334D4200D3CDC8FFC22F
Initialize Memory ...
DRAM already initialized by Preloader
DAgent sent , init HW now
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0x15 , OEM : 0100
[eMMC] : FLASH_INF : [SAMSUNG] , BM328
[eMMC] : FLASH_CID : 150100513832334D4200D3CDC8FFC22F
[eMMC] : FLASH_BRT : 0x00400000 , 0x00400000 , 0x00400000
[eMMC] : FLASH_LEN : 0x00000003A3E00000
[eMMC] : FLASH_UCP : 14910 MiB [eMMC 16 GiB]
DEV RID    : 0xA22D2F435080A0F24702C44E2DE0FD31
INT RAM    : 0x00020000
EXT RAM    : 0x80000000 [2 GiB]
BOOT TYPE  : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

IMEI [00] : 8690450********
IMEI [01] : 8690450********

Set IMEI [00] : 8690450********
Set IMEI [01] : 8690450********
Prepare finished. Security check required!

Wait for phone...
Phone found! [ 4 ]
Sync...
Device boot not done
Check Drivers
Try again

Error while post-checking procedure! Check drivers and battery charge!
In some cases - need reconnect mobile (just re-insert cable) on this step
Reconnect Power/Cable!

Finish at : [26-09-2016 / 13:37:29]


Shows error on CM Software BUT IMEI CHANGED ;);)

USB Debugging is turned ON

IF DA DL FAILED –

Related:

  • lenovo a7000-a 6 0 imei error