lg p895 after repair emmc same dead


hi
my lg p895 dead in flashing and get only apx drive i try repair with atf here is
logs

================================================== ====
================================================== ====
eMMC Test Point Connection Module
================================================== ====
================================================== ====

1. DO NOT USE THE PHONE"S BATTERY
2. Connect the Soldered TP Connections to ATF Box
3. Disconnect the USB Cable and Wait until the
the ATF Software will tell you to Connect the USB.

Interface Reset OK!
eMMC Access Type: SECTOR MODE
eMMC Supported Voltage Range:
3.5-3.6V, 3.4-3.5V, 3.3-3.4V, 3.2-3.3V, 3.1-3.2V
3.0-3.1V, 2.9-3.0V, 2.8-2.9V, 2.7-2.8V, 1.9-2.0V

CID : 90014A484247346504010054A90DAF11
CSD : D02701320F5903FFFFFFFFEF8A4040D3

eMMC Boot Information
Revision 1.5 (for MMC v4.41)
BOOT PARTITION : NOT BOOT ENABLED
PARTITION ACCESS : R/W USER PARTITION
PERM_BOOT_CFG_PROT : DISABLED
PWR_BOOT_CFG_PROT : DISABLED
BOOT MODE : x1 SINGLE DATA RATE + LOW SPEED
RESET BUS WIDTH : ENABLED
eMMC FirmW UPDATE : DISABLED
EMMC CACHE SIZE : 0 KB
SUPER PAGE SIZE : 3584 KB
HC ERASE GROUP SIZE: 512 KB
USER AREA SIZE : 31272730624 BYTES
BOOT PARTITION SIZE: 2048 KB
RPMB PARTITION SIZE: 2048 KB

eMMC Device Information
Manufacturer ID: HYNIX
Device Type : Embedded BGA
Application ID : 4A
Product Name : HBG4e
Product Rev : 0.1
Product SN : 0054A90D
Manufactured : January 2012

Card Specific Data
CSD_STRUCTURE : Extended
SPEC_VERS : Version 4.1/4.2/4.3
TAAC : 13 ns
TRAN_SPEED : 4000000 KHz
READ_BL_LEN : 512 Bytes
C_SIZE : HIGH CAPACITY
WP_GRP_ENABLE : YES
WRITE_BL_LEN : 512 Bytes
CONTENT_PROT_APP : NO
PERM_WRITE_PROTECT: NO
TMP_WRITE_PROTECT : NO

Extended CSD Saved:
90014A484247346504010054A90DAF11.ext_csd
Backup Directory:
C:\AdvanceBox Turbo Flasher\eMMC\EXT_CSD\

Start Writing 0x00167840 Blocks at 0x00000000
Partition Selected: USER AREA

Total Elapsed Time 00:22:17
Write Success!

but after repair same its dead and get apx driver where i mistake in repair please little guide me
Thanks