Micrommax a250 always show wrong flashing ffile

WHEN I TRY TO FLASH MICROMAX A250 IT ALWAYS SHOW-

BLVersion : 0x0001
PreLoader : Active [ Boot with PL ]
BootLdrSS : NORMAL with SPRELOADER
Processing DA stage
DA Select done, will use MTK_AllInOne_DA_v5.1552.01.01
Sending and initialize DA …
Running DA ver.3.2 on BBID : 0x86
NAND Flash : NOT INSTALLED
eMMC Flash : 3000011139473631D22200323F70E6C5
Initialize Memory …
DRAM already initialized by Preloader
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0x11 , OEM : 0100
[eMMC] : FLASH_INF : [TOSHIBA] , 29G61
[eMMC] : FLASH_CID : 1101003031364739320022D2C5E6703F
[eMMC] : FLASH_BRT : 0x00400000 , 0x00400000 , 0x00080000
[eMMC] : FLASH_LEN : 0x00000003AB400000
[eMMC] : FLASH_UCP : 15028 MiB [eMMC 16 GiB]
DEV RID : 3AB010436461837BAA647024D7EB687A
INT RAM : 0x00020000
EXT RAM : 0x80000000
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!

ScatCFG : BaseBand : MT6589 , Project : MTK6589 , Storage : eMMC
Setting : Flash Pre-Erase (Safe) : Enabled
Setting : AFF verify : Enabled
Setting : HW verify : Enabled

BL : Check HW compatibility
BL : BBID supported by BootLoader!
BL : Check eMMC compatibility
BL : eMMC NOT supported by BootLoader!
[BL_ERROR] : STORAGE : Break Flashing! This Firmware will kill phone!

Operation Failed
Elapsed: 00:00:14
Reconnect Power/Cable!

I LOAD OG FILE FROM MICROMAX FTP, BUT WHEN I FLASH WITH SP TOOL SET OK, HANDSET SHOW UNFORTUNATELY ERROR PROBLEM.