PROBLEM HUAWEY G510-0251 Remove Write Protection


that’s the same problem with two different iphones
g510-0251 (EMMC readonly)
I can not Remove Write Protection
EMMC direct CONNECTION without desoldering

I have watched many times my tp the EMMC and this good

emmc= KMSJS000KA-B308

Will I have my EMMC desoldering the pcb?

help me please

Note: Two Huawey Y300 (EMMC readonly) were successful work without desoldering EMMC (KMSJS000KA-B308)

log

===============================================
eMMC Test Point Connection Module
===============================================
===============================================

1. DO NOT USE THE PHONE"S BATTERY
2. Connect the Soldered TP Connections to ATF Box
3. Disconnect the USB Cable and Wait until the
the ATF Software will tell you to Connect the USB.

Interface Reset OK!
eMMC Access Type: SECTOR MODE
eMMC Supported Voltage Range:
3.5-3.6V, 3.4-3.5V, 3.3-3.4V, 3.2-3.3V, 3.1-3.2V
3.0-3.1V, 2.9-3.0V, 2.8-2.9V, 2.7-2.8V, 1.9-2.0V

CID : 150100534A5330304103474A413D1107
CSD : D02701320F5903FFF6DBFFE78A406033

eMMC Boot Information
Revision 1.5 (for MMC v4.41)
BOOT PARTITION : NOT BOOT ENABLED
PARTITION ACCESS : R/W USER PARTITION
PERM_BOOT_CFG_PROT : DISABLED
PWR_BOOT_CFG_PROT : DISABLED
BOOT MODE : x1 SINGLE DATA RATE + LOW SPEED
RESET BUS WIDTH : ENABLED
eMMC FirmW UPDATE : DISABLED
EMMC CACHE SIZE : 0 KB
SUPER PAGE SIZE : 2560 KB
HC ERASE GROUP SIZE: 512 KB
USER AREA SIZE : 3909091328 BYTES
BOOT PARTITION SIZE: 1024 KB
RPMB PARTITION SIZE: 128 KB

eMMC Device Information
Manufacturer ID: SAMSUNG
Device Type : Embedded BGA
Application ID : 00
Product Name : SJS00A
Product Rev : 0.3
Product SN : 474A413D
Manufactured : January 1998

Card Specific Data
CSD_STRUCTURE : Extended
SPEC_VERS : Version 4.1/4.2/4.3
TAAC : 13 ns
TRAN_SPEED : 4000000 KHz
READ_BL_LEN : 512 Bytes
C_SIZE : HIGH CAPACITY
WP_GRP_ENABLE : YES
WRITE_BL_LEN : 512 Bytes
CONTENT_PROT_APP : NO
PERM_WRITE_PROTECT: YES
TMP_WRITE_PROTECT : NO

Extended CSD Saved:
150100534A5330304103474A413D1107.ext_csd
Backup Directory:
C:\AdvanceBox Turbo Flasher\eMMC\EXT_CSD\

Task Selected: Samsung Remove Write Protection
================================================== ====
–> DO NOT PERFORM THIS ON A NON SAMSUNG BRAND EMMC
–> Make Sure you BACKUP eMMC DUMP Just In Case…
================================================== ====

Block Write CRC Error 0x02
ERROR: SET_BLOCK_LEN (CMD16) A3
Check your Test Point Soldering!